|Date Added:||19 February 2015|
|File Size:||53.3 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
When the profibu are very close together, there is a large chance that reflections in the data communication small short circuits can be caused by the input capacitance.
Rate this document Select a Rating 1 – Poor 2 3 4 5 – Excellent. Prototyping and feasibility analysis Startup, consulting, and development assistance System integration Migration and upgrade assistance For more information on NI professional services and the Alliance Partner Network, see ni.
How many DP slaves can I configure in a network? Only one master has the right to control the outputs of each specific slave safety feature.
You specify which slave devices the master should find on the bus as well as which information should be transferred from the master to each slave during this startup phase. With extensive training options for new and experienced users, we can help you reduce development time and costs through faster learning and increased productivity with your NI hardware and systems.
The effect is much less common at transmission speeds lower than 1. But even this short cable has to be terminated at both ends.
Setting Up the CompactRIO PROFIBUS Module
Address 2 could also be blocked for slaves. You then save this bus prrofibus and generate the configuration database. Select the CompactRIO master module in slot 1. Do not exceed kabview devices per segment including repeaters, OLMs, and couplers. Thus, bus contention is not a problem because only one master can control the bus at any time, and a slave device must respond immediately to a request from a master.
However, addresses and have special uses and may not be assigned to operational devices.
C Series PROFIBUS Interface Module – National Instruments
The last profibuw of diagnostic block is used to report channel-related diagnostics. Scanning not activated Slave Mode: If a slave device fails and must be replaced, the master recognizes that a replacement device of the same type and with the same PROFIBUS address has been attached to the bus.
The addressed slave immediately responds with its input data. The standard diagnostics six bytes that every slave device is required to report contain information that is generally related to startup problems.
The higher the baud rate labvieq the longer the cable, the more important termination becomes.
Are the addresses correctly set? Termination prevents reflections that can disturb the data communication. The total number of DP slaves that you can incorporate in a data exchange is because the lzbview uses an address and there are reserved addresses, 0 and these are blocked by the configuration tool.
PXI PROFIBUS Interface Module – National Instruments
No short circuit or break in the cable? Make sure the segment length is in contrast with the baud rate. Back to Top 2. Service Programs for Hardware At NI, we labvview high-performance hardware and are committed to helping you maintain that performance for years to come.
PROFIBUS Interface Modules for NI CompactRIO
Every segment has to be terminated. The installation process varies for different configuration tools, but it is extremely simple. Submit all questions to the Industrial Communications forums for a timely response: Back to Top 5.
Double-click on the master icon to configure the master address, baud rate, profile, and other properties.